Thread: Seadoo Ecu and Tps reset
03-18-2013, 07:24 AM #1
Seadoo Ecu and Tps reset
I have installed a new programmable ecu. I have installed a cable tps. I have set the tps open/close butterfly to the closet position. I connected the pc and set tps in 0 position and the open fully the butterfly and set as 100% open.
Then i installed cable in the ski and screw it up to the cable is quite tighten. I turn on ski and it does not start. It seems too rich and i need to open a little the butterfly tps.
Now the ski started, but my question is to connect the pc and set as 0% position tps with the new position of butterfly (more open then before) or not?
03-18-2013, 06:47 PM #2
What is the tps procedure to reset it? Any idea in the manual operator?
03-18-2013, 07:02 PM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Vern in forum 4-Tec PerformanceReplies: 4Last Post: 08-04-2009, 02:33 PM
By wisconsin_quat in forum Sea Doo ClassifiedsReplies: 0Last Post: 05-27-2009, 07:11 PM
By pwc guru in forum Sea Doo ClassifiedsReplies: 2Last Post: 05-05-2008, 08:58 AM
By JRW1484 in forum 4-Tec PerformanceReplies: 10Last Post: 02-16-2006, 08:51 AM
By seadoo1120 in forum 4-Tec PerformanceReplies: 15Last Post: 08-02-2005, 12:00 PM