03-18-2013, 04:54 PM #1
Supercharger slip effort increased?
Checked my supercharger slip last night.
It was set at 125in/lb 30hrs ago.
Using the same torque wrench, my dial CDI torque (that has not even been used since last time)
I got a reading of 150in/lb.
I cant see how my CDI wrench would have changed calibration
Last time i was struggling to get slip into it so it has a full set of mcmasters + 1 or 2 shims.
03-18-2013, 07:50 PM #2
I have had happen 2 before ....
Don't know how but I wanted higher slip , so worked out well and has stayed the same....
03-19-2013, 08:06 AM #3
Happens lot of times the washer faces get seated better after a few runs. Also to ambient temp weather outside readings will change too I try to get a temp reading if its cold when I tourqe things
03-19-2013, 08:34 AM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MIARider in forum 4-Tec PerformanceReplies: 17Last Post: 05-16-2011, 01:26 PM
By Pirates81 in forum 4-Tec PerformanceReplies: 33Last Post: 08-19-2009, 07:11 PM
By dave262626 in forum 4-Tec PerformanceReplies: 10Last Post: 05-03-2009, 07:40 PM
By brendus in forum 4-Tec PerformanceReplies: 14Last Post: 12-15-2008, 09:43 PM
By STSPERFORMANCE in forum Sea Doo Open DiscussionReplies: 1Last Post: 09-28-2008, 07:29 PM