03-22-2013, 06:54 AM #1
short runner aluminum intake 70 mm tb on supercharged ski opinions?
Has anyone ever ran a Malvin type short runner intake with an
ET 137+4 ? Any opinions would be great
03-22-2013, 07:00 AM #2
BRP put long runners on the 1500 for a good reason
the shorter the runners the less low end torque, off boost of course
03-22-2013, 07:32 AM #3
I did a couple of years ago. Performance suffered tremendously. Went back to stock type manifold.
03-22-2013, 07:37 AM #4
BTW this would be for a drag ski only if that makes
03-22-2013, 08:02 AM #5
from what iv read they are ok for racing but not rec because they are very "on" or "off"
03-22-2013, 08:23 AM #6
03-22-2013, 08:56 AM #7
03-22-2013, 01:10 PM #8
Works fine on turbo application. Sucked on Rude 1
drop in. I have the whole setup on my turbo boat.
03-22-2013, 02:48 PM #9
[QUOTE=Poppa Dawg;2128176]Works fine on turbo application. Sucked on Rude 1
drop in. I have the whole setup on my turbo boat.[/QUOTe
need to run a big sc then all will be good.
03-22-2013, 03:05 PM #10
He said he had a 137. Might be ok with a 3. I personally Would stick to something closer to stock runner design for SC application, unless you can get your hands on one to experiment with because although sweet, Malvins intake is not cheap.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By novaprop67 in forum 4-Tec PerformanceReplies: 9Last Post: 06-19-2008, 06:59 PM
By bigbuck12345 in forum 4-Tec PerformanceReplies: 85Last Post: 04-27-2008, 11:56 PM
By TURBO TECH P.R. in forum 4-Tec PerformanceReplies: 7Last Post: 04-26-2008, 10:31 AM
By Seadooracer9 in forum 4-Tec PerformanceReplies: 5Last Post: 03-02-2008, 08:55 PM
By rancarts in forum 4-Tec PerformanceReplies: 0Last Post: 06-16-2007, 09:21 AM