Thread: kawi 550 wear ring bulge?
03-25-2013, 07:57 PM #1
kawi 550 wear ring bulge?
how do I keep the wear ring from bulging on my older kawi 550?
I rinse with fresh water real good, and lots of WD-40
04-09-2013, 02:18 AM #2
- Join Date
- Dec 2005
If it's still round,seal off the front side with a small amount of JB weld or epoxy then stick some sacrificial anodes around the bottom.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MikeTrin in forum Sea Doo How To & FAQsReplies: 7Last Post: 06-19-2007, 03:05 PM
By shortee in forum 4-Tec PerformanceReplies: 12Last Post: 06-18-2005, 09:36 PM
By INDY27 in forum 4-Tec PerformanceReplies: 18Last Post: 05-25-2005, 08:41 PM
By watermedic in forum Sea Doo Open DiscussionReplies: 6Last Post: 05-18-2005, 09:12 AM
By nitro rxp in forum 4-Tec PerformanceReplies: 16Last Post: 05-12-2005, 05:58 PM