Thread: Honda F12X air intake MOD
03-27-2013, 03:11 PM #1
03-27-2013, 10:40 PM #2
like run the intake to where its pullin air strait from outside? Id be careful considering water ingestion is not cool...... Just re-route it to the front of the hull away from the motor but higher up in the hull to keep away from water!
03-28-2013, 08:15 PM #3
03-30-2013, 07:56 AM #4
Thanks Mac/Boost I’ll take them out the intake pipes and put them high inside the hull.
04-02-2013, 07:59 PM #5
being open loop, the honda runs much cooler than other craft and does not even have a water thermostat! Heat soak is a result of the intercooler and turbo heat soaking, not so much the inside of the hull.
04-04-2013, 11:15 AM #6
The best heat fix I did to my ski was doing g a strait exhaust. It cut in hull temps in half temps were 120-130 now they r within degrees of outside temps .
The big problem with this is having h2o make one timely ....
Also need to be careful not to flip ski or water could get to turbo .
The sound is awesome but is annoying at times ...
One could insulate the water box really good this would probably give compatible results if done correctly .
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Skips313 in forum Kawasaki PWC Performance (4-stroke)Replies: 7Last Post: 06-05-2007, 01:04 AM
By TM1 in forum Sea Doo Sport BoatsReplies: 4Last Post: 03-17-2007, 11:36 AM
By holdnon72 in forum 4-Tec PerformanceReplies: 3Last Post: 02-24-2007, 10:06 PM
By cyoungesq in forum Sea Doo Sport BoatsReplies: 4Last Post: 06-05-2006, 05:27 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 38Last Post: 06-23-2005, 11:53 PM