Thread: pro 785 parts day
03-31-2013, 04:40 PM #1
pro 785 parts day
I am installing a few parts on my new 785 today.
I am going premix and have searched around and read the tech pages. I am removing the oil unit and putting a plate in front of it and will be install a 40 ohm resistor between the oil sender wires so my MFD wont flash at me.
THe only question is I was looking through an old Hot seat catalog and it said that Fujis need a plug and plate.
The pictures will show more. This black block off plate is what I have, will this be enough and work or do I need a plug?
03-31-2013, 06:18 PM #2
03-31-2013, 06:20 PM #3
Last edited by Kerminator; 04-11-2013 at 08:37 PM.
04-11-2013, 08:37 PM #4
04-12-2013, 07:18 AM #5
Can the oil injection.. Yes you will need the block off plate along with a plug. The plug actually takes up the crank volume where the oil injection gear was. Its not a total show stopper if you run without the plug but you may want to take the oil injection gear and have it shortended as you won't be able to install the block off plate and use that for the plug if you cant find one.
04-13-2013, 02:54 PM #6
anyone on here have a plug for the oil injection block off? I checked ebay, none at this time..
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By spraydrice in forum Polaris ClassifiedsReplies: 0Last Post: 05-25-2009, 09:33 PM
By Polarisracer166 in forum Polaris ClassifiedsReplies: 2Last Post: 09-10-2008, 01:27 PM
By jabbas in forum Polaris ClassifiedsReplies: 0Last Post: 06-05-2008, 07:57 AM
By racer447 in forum Polaris ClassifiedsReplies: 3Last Post: 05-31-2008, 01:18 AM
By mnpro785 in forum Polaris ClassifiedsReplies: 8Last Post: 05-02-2008, 10:51 PM