04-03-2013, 09:33 AM #1
Kawasaki start switch spliced on gp1200r
Anyone know which wires go where to splice the kawi start switch to the gp1200r electrical?
09-26-2013, 11:21 AM #2
- Join Date
- Aug 2013
did you ever get around to making this work?
im looking to do the same
10-06-2013, 05:09 PM #3
Yes I did, worked perfect/ I was gonna PM you but I thought Id help anyone else that needs it. All the wires were color coded. I just followed the lines if colors didnt match. I then recorded what the wire did on kawa side. I used masking tapes on each of the gpr S/S wires and wrote what they did. I cut the kawa S/S with 3-4 inches of wire and hooked them up accordingly.
The odd thing about looking at the setup after heat shrinking and soldering the wires which is pretty plug and play/straight forward and I by no means a electrican; is that the kawa S/S fits PERFECT under the trim. I used stub grips on both sides (I could of used a standard size on the throttle side). I have a few pics of the mod below.
10-06-2013, 05:25 PM #4
Unfortunately I do not have a step by step but:
Above link has a few writeups with pics (further into the thread since its old)
I cut the old trim off and used stub grips
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By retro in forum Polaris Open DiscussionReplies: 24Last Post: 07-23-2009, 09:36 PM
By krispaintballz in forum Yamaha ClassifiedsReplies: 5Last Post: 06-08-2009, 07:19 PM
By krispaintballz in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-01-2009, 11:39 PM
By DaBigHert in forum Yamaha ClassifiedsReplies: 5Last Post: 05-28-2008, 09:37 AM
By mrbtd in forum Yamaha Open DiscussionReplies: 3Last Post: 02-13-2008, 05:17 PM