04-10-2013, 10:29 PM #1
R&D Fuel pressure regulator questions
Is anyone running the R&D RRFPR with an aftermarket fuel rail? I am going to be using one of Danny's rails and was wondering if I could just block off the return line on the regulator since I will be running a flow through system with a fuel bulkhead fitting in the top of the tank cap. Anyone see an issue with doing this?
04-11-2013, 10:33 PM #2
Here ya go. These diagrams should help ya out with what you are working with so you can see the two options dead head rail and flow through. You will still want to use the return line on the regulator.
04-11-2013, 11:11 PM #3
Perfect! Thanks Gus!
04-12-2013, 08:20 AM #4
Does anybody have a link to some small liquid filled fuel pressure gauges that u can connect to a aero motive fpr
04-12-2013, 08:43 AM #5
This is the one I have been using with good luck, but any 0-100 PSI with 1/8" NPT male fitting will work. Internet is slow and Summit Racing was not responding so I could not find others, but this should help point you in the right direction.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Quinton Robbins in forum Open DiscussionReplies: 5Last Post: 05-24-2012, 08:29 AM
By wave15stx in forum Yamaha PWC Performance (4-stroke)Replies: 10Last Post: 04-18-2011, 06:00 AM
By boostaholic in forum 4-Tec PerformanceReplies: 5Last Post: 08-19-2010, 04:23 PM
By ercBOOSTED in forum Yamaha PWC Performance (4-stroke)Replies: 4Last Post: 04-26-2010, 07:09 AM
By Red Devil in forum 4-Tec PerformanceReplies: 8Last Post: 12-17-2007, 09:19 PM