Thread: 550 build
04-15-2013, 08:37 PM #1
- Join Date
- Mar 2013
- atl ga
starting my first build so newbie question will be said, with that said this is what i have
i bought a 87 js550 complete and a 78 440 hull for 300 together
the 550 they said it has a bad starter but its good so i found out it was the silnoid so i ordered it.
it has not been run in 2+ yrs but it is NOT locked up.
it has an open west-coast intake, finger throttle , ocean pro ride plate , bilge pump.
1. what should i do to get it rdy to run
2.it has a messed up pump(can i use a 440 pump on it ) the wear ring is not there or can i take the 440 wear ring off
3. when i get it running what mods should i get ?
4 when i finish every thing what should i paint it and what paint and primer should i use
5. when i took the pump out of the 440 it came off ezley but the impeller stayed attached to the shaft with a stick with some green slime on it. it wont come off. did i brake it? what should i do ?
also looking for a js300, 440 550 650 750 850 engine and ebox
will post better pics this weekend
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By dirtydave916 in forum Kawasaki PWC Performance (2-stroke)Replies: 8Last Post: 06-21-2011, 11:30 PM
By PeteSkeet in forum Kawasaki ProjectsReplies: 171Last Post: 05-02-2011, 03:38 PM
By locolife in forum 4-Tec PerformanceReplies: 37Last Post: 07-27-2005, 11:54 PM
By rx4pain in forum Sea Doo Open DiscussionReplies: 0Last Post: 06-07-2005, 09:20 PM