04-17-2013, 02:14 PM #1
Will this press be sufficient for removing bearings on S/C?
Are most of you using a press to install and remove the bearings when rebuilding S/Cers?
If so, what are your thoughts on this 1 ton press?
...or would I need to step up to this press?
04-17-2013, 04:49 PM #2
Hmm, not looking like it will be tall enough to press the shaft out of the housing. What do all of you do?
04-17-2013, 04:51 PM #3
04-17-2013, 04:52 PM #4
to small,not enough clearance...
04-17-2013, 04:53 PM #5
04-17-2013, 05:34 PM #6
04-17-2013, 05:35 PM #7
04-17-2013, 06:22 PM #8
I'm not fond of wasting $$$ either but when it comes to tools, buy quality!
04-17-2013, 10:48 PM #9
Just use your 20 ton. No need for a bench top model if you already own a 20 ton. I've used my 12 ton and the 20 ton at work to rebuild them.
A harbor freight press will work just as good as any other press. It's a press for crying out loud. Some tools don't need to be American made to get the job done. Hell our SeaDoos arent even American made!
04-17-2013, 11:24 PM #10
i bought the 12 ton harbor freight sells and it works good for the superchargers plenty of travel.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By surferd15 in forum 4-Tec PerformanceReplies: 11Last Post: 02-23-2013, 01:07 AM
By fitnessguy in forum 4-Tec PerformanceReplies: 1Last Post: 07-13-2011, 03:21 PM
By jeffz0rz in forum 2-Stroke PerformanceReplies: 1Last Post: 05-21-2009, 06:50 PM
By skirtchaser in forum 2-Stroke PerformanceReplies: 8Last Post: 05-06-2008, 06:17 PM
By seadawg in forum Sea Doo Open DiscussionReplies: 4Last Post: 06-22-2005, 12:44 AM