Results 1 to 3 of 3
  1. #1

    Question intake manifold bolt specs on RXP...

    I removed the intake manifold filter from my RXPX and I am ready to re-install the manifold. The instructions from Riva say do not over tighten, but it does not give torque specs. For something as important as the intake manifold I would like to torque them down evenly... Thanks in advance.

  2. #2

    Join Date
    Jan 2009
    Scotland, UK
    Torque specs are 10 Nm on the bolts, it says to apply Blue Loctite on them before installation. Start at the middle and work your way out to either side.

  3. #3
    Thank you, for everyone who is using a ft-lb torque wrench 10nm = 7.37 ft lbs

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Aftermarket intake manifold bolt size?
    By x2ryder in forum Kawasaki PWC Performance (2-stroke)
    Replies: 3
    Last Post: 06-30-2012, 06:43 AM
  2. Turbo Tech Limited Edition Intake Manifold For Rxt-x/rxp-x
    By TURBO TECH P.R. in forum 4-Tec Performance
    Replies: 13
    Last Post: 07-29-2008, 05:40 AM
  3. Anyone Bolt on a RXP manifold...
    By Pale Rider in forum 4-Tec Performance
    Replies: 12
    Last Post: 04-25-2007, 05:29 PM
  4. Intake Grate Bolts on the RXP
    By Sandy in forum Sea Doo Open Discussion
    Replies: 10
    Last Post: 04-01-2007, 02:48 PM
  5. RXP Intake Manifold
    By HOSS in forum 4-Tec Performance
    Replies: 18
    Last Post: 08-26-2006, 10:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts