Thread: Re opas blockoff removeal
05-05-2013, 05:31 PM #1
Re opas blockoff removeal
Can someone please enlighten me as how to get these RE blockoffs removed after I have installed them useing Right Stuff on the backing plate to the hull?
05-05-2013, 05:47 PM #2
That job can be tough, as you have to go easy to avoid damage to the block offs and the hull.
I used a large putty knife, a razor blade and a screwdriver. Call me when you get a chance
05-05-2013, 05:48 PM #3
Several screw drivers to pry off.
Pita to get off without scarring gel coat.
They will easily bend if not careful.
05-05-2013, 06:42 PM #4
I put a 1x3 in the opening and pry and cut away the rtv
05-05-2013, 11:32 PM #5
I haven't removed mines yet to install my exhaust, but I figured heating would also help in trying to pry off the block off the hull while also using a razor blade to cut the sealant.
05-06-2013, 07:12 AM #6
Pressure will help more than heat will
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By RXTStephen in forum 4-Tec PerformanceReplies: 5Last Post: 12-28-2006, 09:50 AM
By BlaZinMJ in forum 4-Tec PerformanceReplies: 13Last Post: 12-27-2006, 07:45 PM
By rxpblast in forum 4-Tec PerformanceReplies: 7Last Post: 08-01-2006, 06:31 AM
By PAINKILLER in forum Sea Doo Open DiscussionReplies: 13Last Post: 09-15-2005, 02:12 PM
By WildBill9000 in forum 4-Tec PerformanceReplies: 1Last Post: 09-08-2005, 04:43 PM