Results 1 to 4 of 4
  1. #1

    Join Date
    Jun 2008
    Location
    Lake Conroe (Montgomery,) Texas
    Posts
    417
    +1
    10

    1994 Raider. Where to mount primer plunger

    I've got the kit and I'm ready to install it. I know this is just an opinion thing but for those that have done it, where did you install the plunger?


  2. #2
    I just put the plunger in the hole where the old choke lever used to go. it just usually requires a little drilling to make the hole bigger for fitment.

  3. #3

    Join Date
    Jun 2008
    Location
    Lake Conroe (Montgomery,) Texas
    Posts
    417
    +1
    10
    Thanks, 87. I think that I'm going to use the choke cable hole. It's in a little bit of a weird position but I think that it'll be fine.

  4. #4

    Join Date
    Jun 2008
    Location
    Lake Conroe (Montgomery,) Texas
    Posts
    417
    +1
    10
    Got the primer installed in the old choke cable hole. I had to ream it out to about 5/8"+. It was hard getting to the backside of the primer plunger to thread the retaining nut on. I never could get a wrench on it so I hope finger tight will be good enough. Primer works great. Now I need to install the other one that I bought for my GP1200.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking for ideas where to mount hottach II on XPL.
    By Piranha Performance in forum 2-Stroke Performance
    Replies: 5
    Last Post: 12-10-2008, 08:19 AM
  2. Where to mount Graco water strainer
    By Stainless in forum 4-Tec Performance
    Replies: 25
    Last Post: 04-04-2008, 07:42 PM
  3. Where to mount Pet 2100 on GPR?
    By Yellow93 in forum Yamaha PWC Performance (2-stroke)
    Replies: 11
    Last Post: 03-03-2008, 12:22 PM
  4. Need a picture of where to mount this ?!?
    By UnityRacing in forum Polaris Open Discussion
    Replies: 3
    Last Post: 08-21-2007, 12:48 PM
  5. ideas where to mount my pet 2100
    By Hydrotherapy in forum Yamaha PWC Performance (2-stroke)
    Replies: 16
    Last Post: 01-10-2007, 04:28 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •