Thread: Getting high
05-29-2013, 09:30 AM #1
Figured that would get some attention. I am needing some help from any of you that are at 4500-5000 feet with a 300 both stock and have modified it for the elevation.
i appreciate any help I can get.
Last edited by lasportsmn; 05-29-2013 at 10:25 AM.
05-29-2013, 10:12 AM #2
Without a wideband I couldn't tell you if you need to do anything. It might run a but rich but it also might compensate for the altitude by using the initial map sensor reading. Hopefully someone will reply who has experience.
05-29-2013, 10:24 AM #3
Mostly looking for impeller pitch/rpm information.
What rpms are the skis running completely stock with only the SCOM?
What is changed if anything and what results were achieved.
05-29-2013, 01:10 PM #4
At that elevation 7500 rpms stock(stock impeller) with SCOM. Best thing you can do is an impeller depitch - 3mm on the trailing end(stock impeller) to reach 7900 rpms. Take out the hood's rubber seal for more air. O and it's with stock ecu not a reflash. Good luck!
05-29-2013, 01:10 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 98gsxl951 in forum Towing and TrailersReplies: 7Last Post: 07-05-2010, 11:06 AM
By PowerShot in forum Race Events and NewsReplies: 5Last Post: 10-02-2009, 12:47 PM
By spence in forum 4-Tec PerformanceReplies: 8Last Post: 10-01-2008, 05:44 PM
By ron00023 in forum Yamaha Open DiscussionReplies: 27Last Post: 09-22-2007, 03:26 PM
By exodo90 in forum Polaris How To & FAQsReplies: 8Last Post: 06-21-2007, 11:24 AM