05-30-2013, 02:05 PM #1
RXP-X 260 - Pump bolt torque specs
I seem to have lost my pdf shop manual. Anyone got the torque specs for the pump bolts?
05-30-2013, 06:34 PM #2
Not sure if this helps you or not. This is a general bolt/nut torque spec chart off a yamaha pwc manual. Seadoo charges $125.00 for a new service manual, you should give one of their techs a call to confirm the pump bolt torque specs. Most people over-tighten pump bolts and subsequently forget why there is thread locker on the bolts in the first place. Tightening the bolts to their material yield points is a bad idea(shear).
05-31-2013, 01:09 AM #3
- Join Date
- Apr 2013
I have the shop manual PDF for the 05 4tech motor and 05 sportster / challenger seadoo boats... they all used the same 159mm pump if im not mistaken. If you want the pdf hit me up with a PM.
Heres the torque specs from the manual above. (I will note that after doing the initial final torque of 23 ftlbs, let it sit overnight and go back out n retorque em)
05-31-2013, 01:22 AM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By STSPERFORMANCE in forum Sea Doo Open DiscussionReplies: 0Last Post: 09-22-2009, 06:52 PM
By mrbtd in forum 4-Tec PerformanceReplies: 0Last Post: 08-05-2009, 07:09 PM
By boostaholic in forum 4-Tec PerformanceReplies: 4Last Post: 04-12-2009, 06:37 AM
By bigdeez in forum 4-Tec PerformanceReplies: 2Last Post: 10-13-2007, 06:40 PM
By DaGoblinEatR in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 10-21-2006, 11:43 PM