Results 1 to 3 of 3
  1. #1

    Join Date
    Feb 2006
    Location
    Massachusetts
    Posts
    214

    Jetworks valve on 4-Tec?

    I had a jetworks valve on my GP1300R which kept water out of the waterbox at idle and greatly improved the holeshot. I searched, but I didn't find any info about people using a jetworks valve on a 4-Tec ski. Is there a reason why the jetworks valve would not work or should not be used on a 4-Tec?

    Eric


  2. #2
    SLASHER's Avatar
    Join Date
    Jun 2007
    Location
    Australia, Perth WA
    Posts
    3,263
    +1
    474
    The water box gets hot really quick with a 4 tec and the temp sensor will go off setting it in limp mode ...

  3. #3

    Join Date
    Feb 2006
    Location
    Massachusetts
    Posts
    214
    I figured there had to be a reason nobody was using them. Thanks for the info!

    Eric

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. jetworks valve on 99 ZXI 1100 want to be sure of placement
    By [email protected] in forum Kawasaki PWC Performance (2-stroke)
    Replies: 0
    Last Post: 06-15-2012, 11:17 AM
  2. Where to connect jetworks valve on wave venture
    By TrippleVenture in forum Yamaha Old School Skis
    Replies: 12
    Last Post: 02-21-2012, 01:39 AM
  3. Valve Job needed on 4-Tec at 100 hours?
    By Chucke.b in forum 4-Tec Performance
    Replies: 10
    Last Post: 05-03-2011, 06:58 PM
  4. Jetworks valve on a domestic
    By bgaidan in forum Polaris Open Discussion
    Replies: 1
    Last Post: 04-10-2011, 11:26 AM
  5. Compression on 4-Tec Supercharged Engine
    By ramnj in forum 4-Tec Performance
    Replies: 5
    Last Post: 04-22-2006, 08:22 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •