Thread: R&D intake grate
06-12-2013, 03:05 AM #1
R&D intake grate
Does anyone else have a problem with r&d grate not sitting flush with ride plate on 2012 rxt x. How can I fix this?
06-12-2013, 03:23 AM #2
Yes , we all did !
I used a sanding disc on my angle grinder to make flush
06-12-2013, 03:50 AM #3
06-12-2013, 08:57 AM #4
Had to grind and file the low bits .... Fitted 3 and all the same ...
06-12-2013, 08:15 PM #5
Do you grind the side that sits on the hull or the side that you see when it's bolted up
06-12-2013, 11:14 PM #6
I used a hand file on the underside to make it sit flush with the ride plate and an equal amount up front. Mine still pulls to right above above 70 mph.
There are a lot more comments about this in this thread: http://www.greenhulk.net/forums/showthread.php?t=173742
06-13-2013, 12:28 AM #7
Yeh sanded the underside too , and still pulls to the right
06-13-2013, 04:42 AM #8
Thanks for the info. So is there a point of sanding it flush if it still pulls to the right
06-13-2013, 06:48 AM #9
I don't have any pull to right ....???
06-13-2013, 06:54 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By kenshin89 in forum 4-Tec PerformanceReplies: 11Last Post: 03-17-2007, 02:09 PM
By Jeff C in forum 4-Tec PerformanceReplies: 10Last Post: 08-15-2005, 01:32 AM
By 01xdime in forum 4-Tec PerformanceReplies: 8Last Post: 08-12-2005, 09:10 AM
By Krazy-K in forum 4-Tec PerformanceReplies: 1Last Post: 07-12-2005, 09:43 PM
By SUPERBEAST in forum 4-Tec PerformanceReplies: 14Last Post: 06-05-2005, 12:57 AM