06-23-2013, 10:44 PM #1
How many out there have had issues with snapping the stock driveshaft on their ski? If so, what have you done to prevent it from happening again?
06-23-2013, 11:28 PM #2
Turbos tend to produce massive torque when they come on your ski is raw bro maybe cryo treat one ?
06-24-2013, 12:13 AM #3
06-24-2013, 06:19 AM #4
You gotta be kidding! Did it break?
06-24-2013, 06:29 AM #5
I've broken 2 now
Stock lasts the longest. Alignment needs to be right, but around 22psi, or more they don't last
Lacey makes a shaft, not sure how well they hold up on Rec boats. They run them on their race boats
06-24-2013, 06:55 AM #6
Dam first thing I can say is I'm sorry for the recent shaft issue that led to a Motor Damage ( unforeseen). I get poked at all the time about my project and it might not stop these issues but after last event where 22 men entered and 6 DNS I will take my time. I spent two days aligning my motor, excessive probably may prevent problems but ATLEAST there's no what if's
06-24-2013, 07:24 AM #7
06-24-2013, 07:30 AM #8
Are you shittin me!?!? I quit! This was a freakin stupid idea!
06-24-2013, 07:57 AM #9
06-24-2013, 09:05 AM #10
I had a garbage SBT shaft break last time (don't ever buy one!! )
Only way to get it out was to weld a lump on the back of it, to be able
To grab it with pliers.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By dewsy in forum 4-Tec PerformanceReplies: 4Last Post: 01-26-2006, 07:47 AM
By Red Devil in forum 4-Tec PerformanceReplies: 1Last Post: 11-01-2005, 01:49 PM
By Red Devil in forum 4-Tec PerformanceReplies: 15Last Post: 10-26-2005, 12:40 PM
By rx4pain in forum 4-Tec PerformanceReplies: 8Last Post: 06-20-2005, 11:16 AM
By WildBill9000 in forum Sea Doo Open DiscussionReplies: 2Last Post: 06-06-2005, 10:46 PM