Thread: Its all about the Flow
03-03-2007, 09:48 PM #1
Its all about the Flow
Here is a product. I know is ausome. Ive seen it on intake manifolds. And now the company is doing watercraft.The pieces come back beautiful.
03-03-2007, 10:47 PM #2
Extrude Hone does excellent work!!! Has anyone here used them on the RXP or RXT??
03-04-2007, 08:57 AM #3
- Join Date
- Oct 2005
I have seen extrude honed alum intake manifolds in cars before but not plastic...
it was very nice...PR...
03-04-2007, 09:38 AM #4
i wouldn't do it....especially since the manifolds are water jacketed...what happens if they extrude too much , just my 2 cent.
03-04-2007, 10:07 AM #5
03-04-2007, 11:42 AM #6
Thanks for you input Hoss. I have a friend that is going to do his jet pump.Its got some slight corosion in it. I think it should come back perfect.
03-04-2007, 12:11 PM #7
- Join Date
- Jan 2007
I have done three cylinder heads for my ktm motorcycles and the difference is noticeable. they(extrude hone)can control where in the passages the material is to be removed. we left the intake port the same diameter but the pocket over the valves received the most work to keep the flow up. bob
03-04-2007, 01:32 PM #8
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Doug78 in forum Yamaha PWC Performance (4-stroke)Replies: 0Last Post: 06-01-2012, 09:33 PM
By MikeTrin in forum Sea Doo Open DiscussionReplies: 7Last Post: 11-21-2008, 10:16 AM
By Dark_viper42 in forum Sea Doo Open DiscussionReplies: 6Last Post: 05-10-2007, 01:52 PM
By PAINKILLER in forum 4-Tec PerformanceReplies: 14Last Post: 08-13-2005, 09:56 PM
By Therock in forum 4-Tec PerformanceReplies: 3Last Post: 06-04-2005, 08:04 AM