07-01-2013, 01:56 PM #1
700 case/cylinder flange stud thread size?
Does anyone know off the top of their head what size threads and pitch are on the studs referenced in the title line? They appear to be 10 mm x 1.25. I need to buy a die nut to clean up the threads and wanted to confirm that is the correct size.
07-01-2013, 03:40 PM #2
- Join Date
- Jul 2007
- Cedar Rapids,Iowa
M10 X 1.5 is the standard (most common, ISO) metric size. but not sure if that's what they used. Take a nut with you and check it on a bolt.
07-01-2013, 04:30 PM #3
Do you have access to a media blast cabinet? I have found that blasting studs and nuts with Glass bead media does a better job and is less aggressive than a die. All the metric dies I have used seem to be tight and remove too much of the thread, so the nut has too much play when screwing them on. Just my 2 cents of free advice.
07-01-2013, 08:10 PM #4
- Join Date
- Jun 2010
- Milwaukee WI
I use a wire wheel chucked into my drill press to clean up bolts.
07-02-2013, 10:53 AM #5
I use a Wire wheel on my bench grinder here.......
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By K447 in forum Polaris Open DiscussionReplies: 6Last Post: 06-20-2012, 05:54 AM
By lovehavenfun in forum Polaris ClassifiedsReplies: 2Last Post: 06-16-2011, 07:13 PM
By Danny in forum Yamaha Open DiscussionReplies: 8Last Post: 03-25-2007, 01:04 AM
By ZMANN in forum Polaris PWC PerformanceReplies: 6Last Post: 10-31-2006, 01:19 PM
By Yuji in forum 4-Tec PerformanceReplies: 1Last Post: 06-01-2006, 12:12 PM