07-15-2013, 07:36 PM #1
- Join Date
- Jun 2012
97 wave venture 1100 oil question
Going to go premix. Do I need to do anything other than drain the oil tank and add oil to the gas?
I see there is a block off kit...do I need it? Any harm to not using the kit and just premixing the oil.
One other question, what hose has to be crimped off to two this ski?
07-16-2013, 09:37 AM #2
- Join Date
- May 2013
Lots of info on switching to pre-mix on this forum.
1) Drain oil from tank
2) Tie oil level sensor/floats in the upmost position
3) Remove oil pump + install block-off plate
4) Plug nipples where oil lines enter carbs
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By GatorKev in forum Yamaha How To & FAQsReplies: 2Last Post: 10-23-2012, 09:20 AM
By ianshives in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 06-08-2011, 03:11 PM
By AT_Viper in forum Yamaha How To & FAQsReplies: 1Last Post: 06-06-2009, 12:26 AM
By JacRae in forum Yamaha ClassifiedsReplies: 1Last Post: 04-25-2008, 07:59 AM
By fastkaz in forum Yamaha Old School SkisReplies: 3Last Post: 03-29-2007, 07:03 PM