Results 1 to 4 of 4
  1. #1
    1999-SLTX's Avatar
    Join Date
    Jul 2013
    Location
    phx,az
    Posts
    261
    +1
    2

    99 sltx removing drive line from pump

    I pulled my pump , im new to ski's , waiting on the manual , the drive line feels stuck but will slip in and out almost an 1'' , do I just spray it with wd-40 to losen the o-ring and pull and hit with mallet, just wanna make sure b4 i do anything , lol thanks


  2. #2
    Click avatar for tech links/info, donation request K447's Avatar
    Join Date
    Jul 2007
    Location
    near Toronto, Canada
    Posts
    36,601
    +1
    1,277
    Drive shaft just slides out of the impeller.

    BUT, there is an o-ring inside there that creates an air suction as you try to withdraw the drive shaft. Put some tension on it, and hopefully the suction will slowly subside as air leaks in and you can keep working the drive shaft out.

    Be careful you don't get hurt when it lets go!

  3. #3
    1999-SLTX's Avatar
    Join Date
    Jul 2013
    Location
    phx,az
    Posts
    261
    +1
    2
    lol I can see it slip out and BAM , lol

    ok the o-ring is all broken up & making it a tight pull out so I will do sum yanking on It later, lol

    thanks 4 the heads up

  4. #4
    ThrottleOut's Avatar
    Join Date
    Aug 2011
    Location
    Corning, NY
    Posts
    727
    +1
    29
    Last I checked the o-ring into the impeller was still available and was under $1.00 at the local polaris dealer. I'd replace it if it's starting to crack or is already gone. Also make sure you have the rubber bumper's in each end of the driveshaft.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Type 13 cooling line from pump
    By fzsaust in forum Yamaha PWC Performance (4-stroke)
    Replies: 9
    Last Post: 02-26-2014, 03:21 PM
  2. Removing Floating ring from Drive shaft
    By Fast-XPL in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 06-08-2010, 02:33 PM
  3. Removing bolts from pump and grate with Red Loctite???
    By iceman1998 in forum 4-Tec Performance
    Replies: 8
    Last Post: 06-17-2009, 11:30 AM
  4. Removing Impeller shaft/bearing from pump
    By PropOrJet in forum Sea Doo Open Discussion
    Replies: 0
    Last Post: 08-18-2007, 12:15 AM
  5. How do I remove Yamabond 4 from pump
    By Fandini in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 07-11-2006, 10:21 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •