Results 1 to 6 of 6
  1. #1
    japhunter's Avatar
    Join Date
    Jul 2013
    Location
    Glendive Montana
    Posts
    59

    New 2000 virage slow speed screw looks different?

    I got my new low speed screw.It is quite a bit different then the old one in my carb.The point looks shorter?It came in Original Polaris package.Still sealed and part # matches with what it is.So would this make a difference? The old one did have some plating missing like it was ran in to far. This is why I was replacing it.My Virage was going bla when I would give it gas.If feathered it would come out of it .Not terrible just annoying.New one on top old one on bottom.
    Click image for larger version. 

Name:	2013-07-25_17-25-58_55.jpg 
Views:	50 
Size:	76.4 KB 
ID:	308037!
    Last edited by japhunter; 07-27-2013 at 12:38 AM.


  2. #2
    japhunter's Avatar
    Join Date
    Jul 2013
    Location
    Glendive Montana
    Posts
    59
    Any one ?

  3. #3

    Join Date
    May 2012
    Location
    McKinney Texas
    Posts
    140
    +1
    5
    I don't think the minor difference will matter.

  4. #4
    Rasta Mon Condoms We Be Jammin!!!!! TxVirageTx's Avatar
    Join Date
    Aug 2006
    Posts
    5,777
    +1
    405
    i'm sure i've got a stock low speed screw for ya

  5. #5
    japhunter's Avatar
    Join Date
    Jul 2013
    Location
    Glendive Montana
    Posts
    59
    Pm on the way!

  6. #6
    ThrottleOut's Avatar
    Join Date
    Aug 2011
    Location
    Corning, NY
    Posts
    727
    +1
    29
    I don't think it'd hurt to run it like that. You may have to turn it in a touch over the factory one but it should be tune-able without a problem.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 10
    Last Post: 08-09-2017, 03:51 AM
  2. 2000 virage bogging down after new fuel hoses.
    By funfinn in forum Polaris PWC Performance
    Replies: 2
    Last Post: 07-21-2012, 05:21 PM
  3. 2000 virage misfires at high speed
    By bobkat1234 in forum Polaris Open Discussion
    Replies: 3
    Last Post: 07-06-2012, 12:33 AM
  4. 2000 virage tx idle set screw problem in carbs
    By twitty in forum Polaris PWC Performance
    Replies: 14
    Last Post: 07-01-2011, 10:03 PM
  5. 2001 Virage - Low speed screw
    By fusion900 in forum Polaris Open Discussion
    Replies: 3
    Last Post: 06-03-2008, 08:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •