07-27-2013, 12:11 PM #1
I can get a mesurement from a GTR owner?
I replaced my wear ring and have reinstalled the IBR bucket and linkage. It seemed a little "different" after the test ride. And was wondering if one of you could give me a measurement between the two red spots on the picture with it at the middle trim indication on dash and with the ski off.
07-27-2013, 12:20 PM #2
Let me go grab my tape and go see if I can get this for you.
07-27-2013, 12:25 PM #3
4'' 1/16. Why the need to replace the wear ring? What happened?
07-28-2013, 07:58 AM #4
Thanks man. Oh, our lake is low and a friend let it get to close to the shore when we were unloading. Sucked up a rock,and all was over.
But on a better note, I did get the Pyle amp and 3" speakers, just need to get them installed.
Last edited by charles_2000; 07-28-2013 at 08:01 AM. Reason: added info
07-28-2013, 09:52 AM #5
if your ski wont sit still in the water now, there is a way to adjust the position through the trim buttons. Look for the procedure in your owners manual.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By spannerspencer in forum MSX/MatrixReplies: 3Last Post: 07-17-2011, 03:14 AM
By fosgate99 in forum Yamaha Old School SkisReplies: 12Last Post: 07-30-2010, 09:18 AM
By beachboy66 in forum 4-Tec PerformanceReplies: 12Last Post: 08-09-2006, 07:00 AM
By 05RXPnoob in forum Yamaha Open DiscussionReplies: 6Last Post: 07-30-2006, 05:03 PM
By 1 FAST VE in forum 4-Tec PerformanceReplies: 76Last Post: 01-29-2006, 08:20 PM