07-27-2013, 02:11 PM #1
05 rxp sc had oil on wheel side when i removed
i removed my sc to check for slip, which i never have done before. i am goin to buy a dial torque gaguge today. The sc had a little oild residue on the bottom where the air inlet is. i am not sure if that is normal or not. I have a 3 inch riva air intake, i know at the fronmt there is a blow by or whatever its called coming off the motor.I bought the sc off ebay for 215 about 15 hours ago. it runs good but i dont hit but around 7950 or so rpms.the guy i bought it from stated it had a new viton oil seal and riva washers.Are there any videos checking sc slip anywhere?
07-27-2013, 02:43 PM #2
- Join Date
- Dec 2006
- Crest Hill, IL
Oil on the inlet is from the blow by attachment up front...If there is oil residue in the discharge tube, then that means the seal is leaking...
Where are you located?
07-27-2013, 02:58 PM #3
More than likely it is from blow by seeing you had a Viton seal installed...Not unless it was installed incorrectly...Is there oiy residue in the air intake???can you post a pic of it...
07-27-2013, 03:04 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By lawracing in forum Conversion PWC Performance SkisReplies: 51Last Post: 02-18-2009, 02:34 AM
By novaprop67 in forum 4-Tec PerformanceReplies: 29Last Post: 04-22-2008, 10:16 PM
By TDSTYG in forum 4-Tec PerformanceReplies: 8Last Post: 09-01-2007, 07:14 PM
By Sandy in forum 4-Tec PerformanceReplies: 8Last Post: 03-27-2007, 08:39 PM
By DANNYA09 in forum 4-Tec PerformanceReplies: 11Last Post: 07-03-2006, 11:45 AM