Thread: Wow!! Can this valve be save???
07-28-2013, 02:13 PM #1
07-28-2013, 02:47 PM #2
If any valves hav had a "HIT" i would replace them, if they are not all the latest type, replace them all anyway, It will most likely need a valve job and clean up, probably give the face a skim.
ll round Id say its perfectly repairable but think yourself lucky, mine was not so "pretty"
07-28-2013, 03:35 PM #3
07-28-2013, 03:40 PM #4
- Join Date
- Aug 2011
07-28-2013, 06:54 PM #5
07-29-2013, 01:42 AM #6
- Join Date
- Aug 2012
Is the block still in the boat? You could put a straight edge on it and check it...
07-29-2013, 06:28 AM #7
07-29-2013, 07:31 AM #8
A straight edge is a perfectly flat piece of metal. Take the bar and go laterally and horizontally and run a feeler gauge under it. I usually drag a .001" under it, and if there is drag the whole length, you can assume it is flat.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jersey785 in forum 2-Stroke PerformanceReplies: 1Last Post: 06-09-2010, 08:35 PM
By camar0 in forum 4-Tec PerformanceReplies: 10Last Post: 03-16-2010, 11:51 AM
By sweetbats in forum 4-Tec PerformanceReplies: 31Last Post: 09-29-2009, 10:08 AM
By lawracing in forum 4-Tec PerformanceReplies: 12Last Post: 06-13-2006, 02:10 AM
By rx4pain in forum 4-Tec PerformanceReplies: 9Last Post: 06-10-2005, 06:04 AM