Thread: Group K Ride Plate!
03-08-2007, 03:28 PM #1
Group K Ride Plate!
Just got my ride plate in this morning, installed it and put the rest of the ski back together, supposed to be a great day here tomorrow. Hope to see the promised 2 mph.Let yall know tomorrow night.
Where you at Shhr?
03-08-2007, 03:40 PM #2Finally someone is going to test and actually ride their ski !!!!
I was almost ready to give up on you guys ........( j/k)
Waiting on my wedge and the spare ride plate is on order
03-08-2007, 03:44 PM #3
I can only test what I have, and I had to pay an extra $50.00 to have it overnighted.I also have a prop coming, so we shall see.
03-08-2007, 03:47 PM #4
03-08-2007, 09:15 PM #5
"Ultra 250", what kind of impeller are you gonna be useing?
03-08-2007, 10:15 PM #6
03-08-2007, 11:42 PM #7
I have 10 hours on my ski now, I took only 2 GPS readings on my last ride , one with a Full tank ( 65.2MPH ) and one with 2 bars down ( 66.3 MPH).
This is without the Wedge and my 210 lbs of rider weight.
By the time I got her down to half a tank of gas, we were in the intercoastal near Naples (fishermen alley that day) and I couldn't do any speed runs. We launched here in Naples and I was out of luck as far as blasting through all the fishing boats on a speed run. My Wedge goes on in the morning , but it'll be a long working weekend,
Tuesday I'm off and will be riding-I'll have some real GPS numbers for you with a 1/3 and then 1/4 tank of gas.
03-09-2007, 01:52 AM #8
I have already done the wedge and exhaust, and a couplle of other little things, Im running in the upper 69's consistently,(yes with low fuel), so hopefully it will push it to the 71's. We shall see.and Ill let you know on the prop when it gets here, dont think this new prop is going to help, but ill try it, while I have the stock one out, Im going to have it tweaked a lil bit.
03-09-2007, 01:58 AM #9
According to Group k, with thei ride plate and a wedge its supposed to gain 3 mph.
03-09-2007, 09:47 AM #10
Did you have to order a larger prop removal tool or will the old 15F/12F tool work ?
I am not sure if they driveshaft is the same diameter on this new 250X
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By tckylem in forum Kawasaki PWC Performance (4-stroke)Replies: 8Last Post: 05-21-2007, 07:04 AM
By Hurricane1000 in forum Kawasaki PWC Performance (4-stroke)Replies: 9Last Post: 03-20-2007, 10:44 PM
By Skips313 in forum Kawasaki PWC Performance (4-stroke)Replies: 20Last Post: 03-04-2007, 01:01 AM
By Kawi-Guy in forum Kawasaki PWC Performance (4-stroke)Replies: 6Last Post: 02-20-2007, 04:48 PM
By shooter98xpl in forum Yamaha PWC Performance (2-stroke)Replies: 12Last Post: 02-22-2006, 12:00 AM