08-05-2013, 04:22 PM #1
Cruse control 2012 RXP x260 Never Quit Challenge
In Sep I will be partaking in a Never Quit Challenge ride (neverquitchallenge.com)....from key west to NYC (1600 miles) I'm in need of a cruse control ()....how hard was it to install? Any pictures or part numbers you can provide for me?
08-05-2013, 06:04 PM #2
- Join Date
- May 2011
- West Texas
Make one! Gives you an excuse to build something!!!
08-05-2013, 07:34 PM #3
08-05-2013, 07:35 PM #4
08-06-2013, 01:23 AM #5
I installed it a few weeks ago on my 260px, it comes with detailed instructions(not px specific) and a few pics. It will take 2+ hours to install. You will need a torx bit to take off dash cover under the mirrors, two each side. Hard part is wiring the cluster connection, need a small pick to get plugs out, make good crimps with wire connectors because holes are small, crimps need to be round, not flat to fit. Wiring to fuse box is easier. Be carefull not to break tab off the plastic throttle cover, access underneath after screws are out. There are no holes to secure module like instructions show to battery harness, get creative with zip ties.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jo2jo in forum 4-Tec PerformanceReplies: 28Last Post: 09-19-2016, 04:10 PM
By BlackHawk in forum Open DiscussionReplies: 10Last Post: 08-23-2013, 06:16 PM
By Tonyrxpx in forum 4-Tec PerformanceReplies: 3Last Post: 05-10-2013, 05:02 PM
By thomas loh in forum 4-Tec PerformanceReplies: 0Last Post: 12-10-2012, 07:06 AM
By wavejunkiefl in forum Sea Doo Build ThreadsReplies: 0Last Post: 02-21-2012, 10:03 PM