Thread: Rod bolts?
08-08-2013, 03:23 PM #1
Do they need to be replace when doing an engine rebuilt? What are the torque values?
08-08-2013, 03:52 PM #2
Yes they must be replaced
45nm + 90 Degrees
(33lbf.ft + 90 Degrees)
These specs are for OEM bolts
08-08-2013, 03:54 PM #3
08-08-2013, 03:59 PM #4
Yes!!!! you definatly want to replace them..Torque spec as per manual-
45 Nm (33 ft lbs)
Do not apply any thread locker
Finish tightening the screws with an additional 90 degree turn using an angle torque wrench.
08-08-2013, 05:19 PM #5
I use engine oil mixed with molly paste or engine oil only
On the threads and the washer, both sides, havnt had any problems and have built 40+ motors
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By dnielsen in forum 4-Tec PerformanceReplies: 1Last Post: 04-29-2013, 04:39 PM
By crashhard in forum Sea Doo ClassifiedsReplies: 0Last Post: 07-19-2011, 12:10 AM
By SHOBiz in forum Yamaha PWC Performance (4-stroke)Replies: 1Last Post: 09-03-2010, 05:58 PM
By boostaholic in forum 4-Tec PerformanceReplies: 9Last Post: 03-09-2010, 01:25 AM
By boostaholic in forum 4-Tec PerformanceReplies: 4Last Post: 04-12-2009, 06:37 AM