08-10-2013, 01:44 PM #1
Powervalve servo repeatedly cycles with ski off
Just started doing this with the ski off. It cycles every few seconds and drains the battery. Ski runs fine otherwise. Any ideas?
08-10-2013, 02:48 PM #2
Check the connections for corrosion / water / etc. clean and try again.
08-10-2013, 03:49 PM #3
it happen to me once , and i find out that one of the cables had more tension keeping the servo busy trying to adjust its position back to 0 .
in other words it was out of adjustment.
08-10-2013, 09:46 PM #4
You can check what the other two people posted, if that doesn't fix the issue you have a bad power valve motor. I had a few on different ski's due the same thing. The motor will work fine while the ski is running, but you will need to disconnect the motor when your not running the ski so it won't run down your battery.
08-10-2013, 11:22 PM #5
Adjusted and lubed the cables. Connector is clean. no change. I have a spare motor I am going to swap in. Yea, I've been disconnecting it for now.
08-14-2013, 03:49 PM #6
- Join Date
- Aug 2013
08-14-2013, 04:12 PM #7
I haven't had time to swap it yet. I forgot to mention that I have a Protec power valve controller as well so I am going to have to wire that in. My cables more freely.
08-14-2013, 04:57 PM #8
08-14-2013, 05:14 PM #9
I have a spare here but if its also bad I'll try it.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Tom315 in forum Kawasaki PWC Performance (4-stroke)Replies: 50Last Post: 03-29-2012, 10:36 AM
By immred in forum 4-Tec PerformanceReplies: 7Last Post: 08-12-2011, 02:52 PM
By Shibby1485 in forum 4-Tec PerformanceReplies: 104Last Post: 09-22-2007, 09:55 PM
By Kinchyle in forum Sea Doo Open DiscussionReplies: 15Last Post: 05-02-2006, 01:29 PM
By ccassone in forum 2-Stroke PerformanceReplies: 2Last Post: 04-20-2006, 06:02 AM