Thread: supercharger bearing failure
08-11-2013, 12:11 PM #1
supercharger bearing failure
I have a 2007 challenger with the 215. Yesterday my supercharger went south. The previous owner had told me that the ceramic washers had already been swapped out to steel.The boat only has 33 hours on it.
When I pulled the sc, it looks like to me that it does indeed have steel washers but the bearings are all gone. Unlees it has ceramic washers between the steel ...how many washers should there be ??It looks like there is 1 washer closest to the housing-the gear-washer-splined spacer-5 spring washers-little round spacer and then the nut.
If it did not have ceramic washer and just the bearings went, do I still have to go thru the engine or will the sceen at the pump catch this. I read of dealers that just put on a new sc and let it ride. I will try and upload a pic of this in a following thread.
Thanks for any help
08-11-2013, 12:14 PM #2
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum 4-Tec PerformanceReplies: 31Last Post: 08-05-2015, 08:07 PM
By Martin RXT-X in forum 4-Tec PerformanceReplies: 15Last Post: 03-29-2014, 03:37 PM
By 06rxp79 in forum 4-Tec PerformanceReplies: 62Last Post: 07-20-2011, 06:04 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 51Last Post: 07-13-2007, 12:13 PM
By MikeTrin in forum Sea Doo Open DiscussionReplies: 52Last Post: 02-06-2006, 07:38 AM