Thread: Power Pipe
03-10-2007, 07:37 PM #1
Can someone tell me if the PPG power pipe and the Rotax power flow pipe have the same bends in them?
Are they alike?
With my PPG pipe installed looks like its going to be fun to route that 4 inch homemade rear air intake!
03-10-2007, 07:43 PM #2
Here is my post from a long time ago when i put the rotax pipe on.
Last edited by ReDevilRXP; 03-10-2007 at 07:48 PM.
03-10-2007, 09:28 PM #3
Looks the same to me!
Now just to figure out how to do my rear air intake!
03-10-2007, 10:35 PM #4
I had to take out my PPG power pipe to use my home made 4inch rear intake. I tried like heck to keep it, but it was a no go. I don't think you can do it, but please post if you do as I would love to see it.
03-10-2007, 10:57 PM #5
So waterfire what did you do instead to make the 4 inch work?
I look down that rear vent and see nothing but that PPG power pipe right in the way
I dont want to redo the rear exhaust either!
03-10-2007, 11:08 PM #6
For the time being I put the stock hose back in with a Joiner.
You will need to do this or go with a Rear thru hull exhaust.
03-10-2007, 11:53 PM #7
I will see what I can improvise!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Sea Doo Open DiscussionReplies: 26Last Post: 06-28-2005, 06:19 PM
By two2curupt in forum 4-Tec PerformanceReplies: 17Last Post: 06-20-2005, 09:16 PM
By Therock in forum 4-Tec PerformanceReplies: 4Last Post: 06-06-2005, 02:56 PM
By joeg in forum 4-Tec PerformanceReplies: 10Last Post: 05-22-2005, 03:24 PM
By Therock in forum 4-Tec PerformanceReplies: 10Last Post: 05-22-2005, 01:54 PM