08-24-2013, 10:29 AM #1
- Join Date
- Aug 2012
2006 4-tec GTX 155hp P0600 fault and checking the circuits. Please Help
I have a P0600 fault in communication system.
I need to check circuits 2-10 & 2-11 or a 1-10 & 1-11. I see this everywhere on the internet and it is the white/red and white/black wire communication loop.
Do I check this circuit to see if it is grounded or check it for vlotage or check a loop for resistance?
Is the best approach to check each sensor individually or should the fault system find bad sensors?
I replaced MPEM because this 2-10 and 2-11 had continuity to ground at the ECM connection.
08-24-2013, 07:02 PM #2
- Join Date
- Jan 2009
- Scotland, UK
First one is.....Communication problem detected by ECM. (Possible Fault)....Damaged circuit wires, damaged connector, damaged ECM output pins. Diagnostic connector cap not connected. Fault detected when the engine is stopped. (Action)....Connect diagnostic connector cap.
Second one is....Communication problem - ECM message missing. (Possible Fault)....Damaged circuit wires, damaged connector or damaged ECM output pins. Fault detected when the engine is stopped. (Action)....Check system circuits B-10 and B-11.
It doesnt say what to check for...so im not sure if this is any help too you.
08-24-2013, 07:09 PM #3
do you have the right gauge cluster for your ecu?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By boostintt in forum 2-Stroke PerformanceReplies: 5Last Post: 04-25-2013, 09:29 PM
By rockguy in forum Sea Doo ClassifiedsReplies: 21Last Post: 11-30-2011, 12:58 PM
By shkdwn387 in forum 2-Stroke PerformanceReplies: 2Last Post: 05-16-2011, 03:40 PM
By hondarepoman in forum Honda How To & FAQsReplies: 7Last Post: 02-22-2009, 03:01 PM
By GTI-SE4426 in forum 4-Tec PerformanceReplies: 1Last Post: 07-19-2008, 05:37 AM