08-28-2013, 07:03 PM #1
Need new crank or can I rebuild? 657cc 95spx
Just got the crankshaft apart after FINALLY getting the PTO flywheel off. It took a strong chain wrench, a 5' steel pipe for leverage, my uncle using his acetalyne torch to heat it up so hot it was glowing red while I was jumping on the pipe trying to turn the flywheel. Unbelievable.
Anyways, a couple of the bearings are broke on the crankshaft. Is this something that can be fixed or do I need to get a new crank? Pictures are attached.
1st picture is a broken bear in the center, 2nd picture is a different view, 3rd picture is the end bearing broken apart in a plastic bag and the last picture is where that bearing used to be.
08-28-2013, 08:05 PM #2
yikes...id replace the whole thing and call it good.. Id hate to tear it back down again for something stupid.
08-29-2013, 05:40 PM #3
if you need a rotary shaft assembly, i have one in great shape and cheap....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By shadowmanzx1 in forum 2-Stroke PerformanceReplies: 4Last Post: 09-05-2010, 09:24 PM
By shadowmanzx1 in forum 2-Stroke PerformanceReplies: 0Last Post: 09-04-2010, 11:34 AM
By wcmateiuc in forum 4-Tec PerformanceReplies: 3Last Post: 05-05-2009, 11:01 PM
By mibunkerking in forum 2-Stroke PerformanceReplies: 11Last Post: 04-18-2009, 07:53 PM
By idizzy in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 12-03-2005, 11:45 PM