Thread: 06 RXP Depth Gauge
09-03-2013, 02:40 PM #1
06 RXP Depth Gauge
I did some research and most say you can not add oem depth gauge to rxp. I came across this rxp which looks like it has oem depth gauge on it. Can anyone verfy this by looking at this picture?
09-03-2013, 02:40 PM #2
09-03-2013, 03:18 PM #3
Bottom left hand gauge shows the same place it is on my 06 RXT.
09-03-2013, 03:30 PM #4
Dont see why (on the face of it) you could not add it to an 06 RXP.
Two routes come to mind, either use a RXT harness to add it to your ski and then add VTS back in as many have done to their RXT's. Plus the sensor or whatever transducer it uses to detect depth. Configure the ECU / Gauges to activate depth sounder and VTS.
Find or make up a loom for the sensor and find out where it pins to on the harness / ECU and add it that way to your ski and configure the ECU to activate depth sounder.
Maybe there is something I am missing but I think it could be done.
09-03-2013, 03:39 PM #5
You just make a harness 4 wires pin it to the MPEM or fuse block 07+ activate with Buds or Candoo siemens ecu bosch is plug and play.
09-03-2013, 03:41 PM #6
09-03-2013, 03:43 PM #7
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Timbo3416 in forum 4-Tec PerformanceReplies: 6Last Post: 12-20-2010, 09:25 PM
By junior in forum 4-Tec PerformanceReplies: 11Last Post: 07-25-2007, 07:35 PM
By murf'n'surf in forum 4-Tec PerformanceReplies: 4Last Post: 12-21-2006, 02:44 PM
By Mark S in forum 4-Tec PerformanceReplies: 45Last Post: 04-17-2006, 09:59 PM
By STEAMBOAT in forum 4-Tec PerformanceReplies: 2Last Post: 11-01-2005, 12:52 PM