03-12-2007, 06:42 PM #1
WOW! Melting Riva Race Flame Arrestor Batman!
I just pulled my Riva Race Flame Arrestor off. I was looking on the inside of the arrestor and you could see where there was melted spots. I mean not all the way through about you could see where the heat or flame his the spots in the openings and melted the inside of it.
Anyone run one of these and see the same thing? What could be the issue? I am about to switch to the ported and stacked throttle bodies anyways but if I have an issue I would like to find out what it is and fix it first.
03-12-2007, 06:48 PM #2
Oh my mods last season when I was running this where...
Race Flame Arrestor
EFI Controller at 5-5-0-8
03-12-2007, 07:04 PM #3
Check the reeds make sure you do not have a bad petal, Or at one time it backfired real bad.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By yamadood in forum Yamaha ClassifiedsReplies: 1Last Post: 04-16-2011, 12:51 PM
By The Wayniac in forum Yamaha ClassifiedsReplies: 1Last Post: 10-17-2008, 02:27 PM
By The Wayniac in forum Sea Doo ClassifiedsReplies: 1Last Post: 10-17-2008, 02:26 PM
By o uncola o in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 09-26-2008, 08:30 AM
By Fandini in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 06-07-2006, 07:48 PM