Results 1 to 4 of 4
  1. #1

    2011 RXT-260 not running correctly

    Got on it and engine light, and iBR light and beeper came on. Turned it off pulled iBR fuse and put back and it was fine. Drove it 30 minutes then got off to let someone else ride it and soon as they tried to take off it just over revved and won't go over 3mph give it gas and over revs but doesn't take off. Any ideas? Did that once before but I switched off and back on and fixed itself. I believe reverse gate is going down but not enough to send backwards? When you take off it sounds and feels like giving to much gas in reverse. ANY IDEAS?


  2. #2
    wotxxxsd's Avatar
    Join Date
    May 2012
    Location
    Orlando
    Posts
    3,928
    +1
    472
    You sucked something up.
    That's probably your over rev issue.
    Check the pump tunnel from under the ski.

  3. #3
    JT jpt7779's Avatar
    Join Date
    Jul 2008
    Location
    Pittsburg, Texas Lake Bob Sandlin
    Posts
    3,849
    +1
    742
    Use the iBr OVR procedure steps to raise the gate, inspect tunnel and pump for debris.

    If all clear and gate raised still doesn't go but revs up, the splines on the drive shaft and impeller are stripped out.

    Good hunting.

  4. #4
    wotxxxsd's Avatar
    Join Date
    May 2012
    Location
    Orlando
    Posts
    3,928
    +1
    472
    2010 had the crap drive shafts not 2011

    Look at your impeller and wear ring to see if they are torn up...

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 2011 rxt- 260 variable trim BROKE! Please help!
    By Widowmaker in forum 4-Tec Performance
    Replies: 5
    Last Post: 07-10-2011, 10:32 PM
  2. 2011 RXT 260 vs. RXT-x 260
    By DigitalCSI in forum Sea Doo Open Discussion
    Replies: 18
    Last Post: 07-05-2011, 07:05 AM
  3. Some fun w/ the new 2011 RXT-260....
    By cmgww in forum Yamaha PWC Performance (2-stroke)
    Replies: 0
    Last Post: 06-06-2011, 10:33 PM
  4. Genesis i not running correctly
    By metriclips in forum Polaris Open Discussion
    Replies: 5
    Last Post: 10-15-2009, 07:52 PM
  5. Not running correctly
    By darrel in forum 4-Tec Performance
    Replies: 4
    Last Post: 07-27-2009, 10:59 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •