Results 1 to 3 of 3
  1. #1

    Sxr 800 cutting out at peek rpm

    Sxr800 cutting out at top rpm put flame arrestors on do I need jetting or tuning in carb
    Last edited by Ray84; 09-09-2013 at 05:57 PM.


  2. #2
    Could be lots of things. Fuel filter, jetting, dirty jets, too lean, too rich... But if it ran fine before and all you added was the flame arrestors then you are probably too lean. Open up the high speed jet in small increments to get more top end fuel.

  3. #3
    john zigler's Avatar
    Join Date
    Aug 2006
    Location
    WI
    Posts
    2,545
    +1
    33
    If you have changed the flame arrestors to aftermarket, this affects the vacuum in the venture of the carbs, and you will need to re-jet, and lower pop off.

    I have jet kits here, if you need.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 2000 rx cuts out at high rpm's
    By Cstang50 in forum 2-Stroke Performance
    Replies: 34
    Last Post: 01-12-2017, 11:00 AM
  2. Genesis cutting out at high rpm
    By captnG in forum Polaris PWC Performance
    Replies: 5
    Last Post: 07-10-2016, 12:27 PM
  3. 96 GTX cuts out at high RPM - rev limiter?
    By demne in forum 2-Stroke Performance
    Replies: 4
    Last Post: 05-30-2015, 08:48 PM
  4. New Kaw Ultra 300x cutting out at 5k RPM. NEED HELP
    By Shelbyelite in forum Kawasaki PWC Performance (4-stroke)
    Replies: 90
    Last Post: 05-01-2012, 10:01 AM
  5. 99 GTX Ltd Cutting out at high RPM
    By Picturemn2 in forum 2-Stroke Performance
    Replies: 8
    Last Post: 09-28-2007, 04:55 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •