Thread: Drive Shaft Change
09-26-2013, 03:26 PM #1
- Join Date
- Sep 2013
Drive Shaft Change
Need help with what is needed to change the drive shaft (parts wise).
I have a 2010 RXP X 260 RS, an engine mount failed which caused the spline on the drive shaft to strip leaving no drive!
Need help in which parts i need to order as i believe its not just the shaft i need?
Can you replace them with a c-clip shaft which have been known to be a better drive shaft?
09-26-2013, 03:36 PM #2
Yes you can use the c clip shaft and its highly recommended because the 2010 shafts were soft and often stripped..
I don't know everything you would need but I'm sure others will drop in soon.
While your in there I'd inspect the bellows and carbon seal..
If it was me I'd just replace them also for piece of mind..
I think all you would need is in the Hulk store..
09-26-2013, 03:39 PM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By CarFanatic in forum 4-Tec PerformanceReplies: 5Last Post: 08-06-2006, 02:13 AM
By hitman in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 08-01-2006, 10:23 PM
By 1FastTrespiper in forum Sea Doo Open DiscussionReplies: 6Last Post: 07-17-2006, 10:47 PM
By chuck in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 02-20-2006, 08:37 AM
By dewsy in forum 4-Tec PerformanceReplies: 4Last Post: 01-26-2006, 07:47 AM