Results 1 to 2 of 2
  1. #1

    Do anyone make a Transom plate seal Kit?

    I just got the parts for the pump seal kit for my 2002 XLT 1200. When I went to re install the pump, I noticed their were two large cavities in the transom plate where the pump shoe attaches.

    My questions are:
    1) Do they make a transom plate seal kit similar to the pump shoe kit?
    2) Do those cavities need to be filled?
    3) If so, do I just use a marine 5200 sealer if a rubber kit is not avaliable?

    It would seem to me after spending all this time and energy, I would like to complete the job correctly.

    Thanks for any feedback.

  2. #2
    Happily Self-Employed WFO's Avatar
    Join Date
    Nov 2005
    Houston, Texas
    I just fill the cavities with the 5200 fast cure you use to seal the shoe to the hull... also dont use the felt seal at the rear of the shoe, just clean that area from shoe to transom and seal that with the same 5200

    here is a GPR how to do... similar to the XLT

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Tip of the day: Transom plate sealing and truing
    By Green Hulk in forum Yamaha PWC Performance (4-stroke)
    Replies: 64
    Last Post: 09-13-2017, 08:45 AM
  2. Anyone make their own "pump seal kit"
    By Bamaha1 in forum Yamaha PWC Performance (4-stroke)
    Replies: 8
    Last Post: 07-18-2013, 10:33 AM
  3. Transom Plate Sealing
    By LT1GMC in forum Yamaha PWC Performance (4-stroke)
    Replies: 2
    Last Post: 11-01-2012, 06:34 PM
  4. transom plate seal?
    By 2fast4u in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 01-14-2009, 11:09 AM
  5. Do They Make Performace Ride Plates for a 2000 seadoo gtx rfi?
    By jcohen17 in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 04-09-2008, 06:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts