Results 1 to 5 of 5
  1. #1
    RXP TJEEZE's Avatar
    Join Date
    Feb 2012
    Location
    LOS ANGELES
    Posts
    170
    +1
    3

    Is my SC to tight or is it fine....

    I checked my slip after haveing it checked by shop and on my torque wrench was clicking around
    18 to 20 lbs on a e-tec137-3 wheel.Is it to much and what would be the down fall from leaving it
    Like that would boost be down or what would happen.


  2. #2
    Moderator Snoman's Avatar
    Join Date
    Apr 2006
    Location
    South Chicagoland
    Posts
    14,688
    +1
    846
    It is a little too tight in my opinion I would set it up to be around 15-16 foot pounds at the most...With it too tight there is the chance of spinning or rotating the thrust collar that is pressed onto the shaft while hooking and unhooking in the chop..When this happens the oil hole gets covered up therefore causing premature clutch,gear and bearing failure...Also with slip set too high there could be a chance of snapping a shaft....
    Last edited by Snoman; 10-02-2013 at 08:15 AM.

  3. #3
    dnielsen's Avatar
    Join Date
    May 2008
    Location
    Shreveport, Louisiana
    Posts
    2,018
    +1
    94
    What he said ^^^^

  4. #4
    RXP TJEEZE's Avatar
    Join Date
    Feb 2012
    Location
    LOS ANGELES
    Posts
    170
    +1
    3
    Thank you i appreciate the info

  5. #5
    Eastside Powersports Slow 91's Avatar
    Join Date
    Sep 2008
    Location
    River Crew CT
    Posts
    4,248
    +1
    544
    use a digital or dial torque wrench.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Had to get towed in today- is it safe to ride my ski tomorrow?
    By DBINX in forum Honda Open Discussion
    Replies: 3
    Last Post: 07-14-2011, 06:42 PM
  2. Replies: 17
    Last Post: 07-13-2011, 05:50 PM
  3. Is my ski running good or it was that FZR
    By 1_Fast_SHO in forum Yamaha PWC Performance (4-stroke)
    Replies: 7
    Last Post: 08-24-2010, 09:44 AM
  4. Is it safe to run my engine....
    By Jolly Roger in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 06-07-2009, 06:50 PM
  5. How Hard Is It To Rebiuld My Engine?
    By jsc7002 in forum Polaris Open Discussion
    Replies: 10
    Last Post: 06-15-2007, 01:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •