Results 1 to 4 of 4
  1. #1
    imp0ster's Avatar
    Join Date
    Dec 2011
    Location
    Palm Harbor, FL
    Posts
    5,037
    +1
    672

    A/F curve for ET CR wheel from 8100 to 8800?

    What's the general slope? I plan on 12.2 @ 8K and am thinking about ending it at 11.8 @ 8800.

    IATs are currently about 2 degrees above water and below air with the X-SC and a Garrett 500 IC


  2. #2
    imp0ster's Avatar
    Join Date
    Dec 2011
    Location
    Palm Harbor, FL
    Posts
    5,037
    +1
    672
    No one?

  3. #3
    That is about right. This stuff changes from one AFR gauge to the next so is a little dangerous to nail down a definitive answer.

    Andy

  4. #4
    imp0ster's Avatar
    Join Date
    Dec 2011
    Location
    Palm Harbor, FL
    Posts
    5,037
    +1
    672
    I re-cal every 6 months on the gauge for the hell of it. 11.8 is pretty damn safe. Planning in advance. Every get a hold of Johnathan?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. WTB - Parts Looking for et 127 wheel.
    By Kmorningstar_rxp in forum Sea Doo Classifieds
    Replies: 18
    Last Post: 02-13-2016, 12:54 PM
  2. WTB - Parts Looking for ET 15.5 sc wheel
    By 305coco in forum Yamaha Classifieds
    Replies: 1
    Last Post: 02-04-2015, 07:06 PM
  3. what twin prop pitch ? for ET 15 wheel
    By isa alnoaimi in forum Yamaha PWC Performance (4-stroke)
    Replies: 7
    Last Post: 12-18-2014, 03:54 PM
  4. Methods for removing the coupler from engine to split cases
    By JoeyDFZS in forum Yamaha PWC Performance (4-stroke)
    Replies: 20
    Last Post: 10-17-2014, 08:30 AM
  5. FS ET 137mm wheel & 3mm Spacer for X-Charger
    By jk in forum Sea Doo Classifieds
    Replies: 1
    Last Post: 09-04-2008, 01:24 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •