Thread: Et127 after break in
10-28-2013, 11:06 AM #1
Et127 after break in
Charger has about 20hrs since rebuild. And of that, about 7-8 hrs with the 127 wheel. What slip number should I be looking for now that all is broken in? Thing has been running flawless and awesome since install. Thanks
10-28-2013, 11:47 AM #2
Try for 13 ft pound , as they warm up they can drop 1-2 ...
Great drop in wheel ...
10-28-2013, 11:48 AM #3
- Join Date
- Dec 2006
- Crest Hill, IL
What was the slip at when installed 7-8 hours ago?
10-28-2013, 11:50 AM #4
slightly off topic but did you put in a viton seal? Seems anything past 10psi will eventually leak past the stocker.
10-28-2013, 12:37 PM #5
I would shoot for around 135 inch lbs if your spinning it 8100 and and 155 if your spinning it to 8500+....
10-28-2013, 01:39 PM #6
about 13lb jay and will settle to 11-12 when hot that's how I had mine setup
10-28-2013, 01:44 PM #7
Was just off 12 ft lbs when I put the wheel on. Sno, only spinning 8100. Just was not sure if you set it high with a fresh rebuild cause it drops when broken in. I guess if it's still 12 ish a shim would be to much? Whats a low ebough number before a shim is needed? As of last ride, all was working very well. 10.5 psi at 8100 with great pull. I might be one of those lucky ones to hit 80 on a stock tune.
10-28-2013, 01:45 PM #8
10-28-2013, 01:47 PM #9
jay we ride mostly flat water.. my 127.. 137 and now 140 don't loose that much slip once set .. all within .5 lb of what it was set at
10-28-2013, 01:48 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By SpeedDemon99 in forum Yamaha PWC Performance (4-stroke)Replies: 50Last Post: 06-07-2016, 10:02 AM
By spinaker in forum Kawasaki PWC Performance (4-stroke)Replies: 8Last Post: 06-28-2011, 02:57 PM
By TheEngineer in forum 4-Tec PerformanceReplies: 0Last Post: 03-22-2010, 10:58 AM
By JET-ITALIA in forum Kawasaki PWC Performance (4-stroke)Replies: 9Last Post: 05-04-2009, 03:25 AM
By benjahw in forum Kawasaki PWC Performance (4-stroke)Replies: 3Last Post: 09-17-2008, 07:13 PM