Thread: Riva Gen 2 Cooler
10-29-2013, 11:50 AM #1
Riva Gen 2 Cooler
Just about to take on the task of fitting a Riva Gen 2 Intercooler into my SHO.
Just wondering if there are any tips or tricks from and fitting experiance .
Thanks in advance .
10-29-2013, 01:04 PM #2
After holding the Gen 2 cooler in my hands and spending plenty of time on the SHO platform my advice is below
10-29-2013, 01:21 PM #3
I found it real easy to connect the couplers to the throttle body by leaning up against the starboard side of the ski and reaching my hands up and under the ic and intake manifold. Kinda like a bear hug. Hope this makes sense and helps. I for one found it a easy install.
10-29-2013, 02:55 PM #4
I took off my valve cover to ease the installation, thats not stated in the instructions. Also check out that the ic intake pipe dont touch the ribbet up top of the hull and there is a good gap because this can cause the ic pipe to wear when the engine moves. Good luck!!
10-29-2013, 03:30 PM #5
Its one of those things that once it finally slides in, you realize it does fit! Remember, rotation is your friend. You may get it first time in, took me 1 hour, second time 2 minutes, 3rd time 30 minutes,sigh.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Yamaha PWC Performance (4-stroke)Replies: 26Last Post: 05-26-2015, 09:24 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 40Last Post: 03-11-2012, 03:07 PM
By b_dolla44 in forum Sea Doo ClassifiedsReplies: 3Last Post: 03-24-2011, 03:44 PM
By Therock in forum 4-Tec PerformanceReplies: 3Last Post: 07-19-2008, 08:09 PM
By Therock in forum 4-Tec PerformanceReplies: 1Last Post: 07-16-2008, 05:05 PM