10-30-2013, 06:24 PM #1
Danny's supercharger tool..........
Got the supercharger tool from Danny today and it works like a charm, super hi quality made in America!
.......definitely a must have for complete disassembly and/or inspection of your inner clutch washer.
Not too sure I like the material these stock washers are made from..... Seem like pot metal.
No hot spots or wear on the gear or the washers. 25 hours on ski.
What are your thoughts on the stock clutch washers on these new superchargers?
10-30-2013, 09:57 PM #2
My new supercharger tool from Danny arrived, too. Haven't used it yet, but I'm planning to attempt my own SC rebuild sometime this winter on the "kids" boat, so I know it will come in handy. I plan on taking photos and doing a step-by-step walk thru on my blog, as well as a review of the tool.
Rock on, Danny!
11-06-2013, 09:16 AM #3
It is a handy tool,It makes taking the gear/clutch asssembly off without fear of dropping the 40 little needle bearings all over the place...it is definatly a nice tool to add to the collection..
12-13-2013, 09:53 AM #4
This sure would make a great stocking stuffer! If I didn't already have one, I'd be emailing the purchase link to my wife.
12-18-2013, 03:10 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum 4-Tec PerformanceReplies: 2Last Post: 10-16-2007, 07:27 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 31Last Post: 10-09-2007, 10:17 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 4Last Post: 09-07-2007, 11:43 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 18Last Post: 04-06-2007, 08:38 AM
By Krazy-K in forum Sea Doo Open DiscussionReplies: 1Last Post: 03-12-2006, 12:25 PM