11-07-2013, 10:08 AM #1
need bracket that mounts riva rrfpr to fuel tank
Like the title says guys I just need that bracket that mounts the for to the top of the tank
Pm me if u got one
11-08-2013, 08:53 AM #2
Steve, I'm not sure if this would apply to your application, but in my regulator setup we used the stock rubber cap for the return setup with an extended -6AN bulk head fitting after taking the tapered end down that bolts to the regulator. (basically converting it into an extended -6AN port fitting) A stainless washer on the underside is all you need to secure the fitting to the cap once the fitting is screwed on. We used an angled 45 degree push lock fitting on the hose, and shortened a fuel submersible hose at an angle away from the pickup in effort to eliminate fuel pump cavitation if the levels got low and the return disrupted the fuel pickup location and level. Here is the bulkhead fitting we used along with the link to one, as well as the port fitting shown where to take the taper off one end. Again, this may help you and eliminate the need for the bracket you are referring to.
here is the ink to one.. http://www.ebay.com/itm/141091116768?ssPageName=STRK:MEWNX:IT&_trksid=p398 4.m1439.l2648
Remove the tapered flare on the regulator side. (match the flat side on the right)
and here is what it looks like finished..
Feel free to contact me if you think this may work for you and have any further questions.
11-08-2013, 09:16 AM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 98gsxl951 in forum 4-Tec PerformanceReplies: 6Last Post: 08-15-2013, 10:06 AM
By peterj59 in forum Yamaha 4 Stroke SkisReplies: 0Last Post: 08-17-2012, 07:55 AM
By ricky86 in forum 4-Tec PerformanceReplies: 6Last Post: 04-23-2012, 03:50 AM
By kwr in forum Yamaha ClassifiedsReplies: 1Last Post: 08-01-2010, 09:57 AM
By thompsdw in forum Sea Doo ClassifiedsReplies: 2Last Post: 04-11-2009, 08:45 AM