Results 1 to 7 of 7
  1. #1

    removing impeller from the housing

    I have the tool , but what do I need for the other side ?
    Looks like allen head but I can't find one big enough.


  2. #2
    Moderator beerdart's Avatar
    Join Date
    Aug 2006
    Location
    CT
    Posts
    25,929
    +1
    1,407

  3. #3
    Matatan tocullo's Avatar
    Join Date
    Nov 2010
    Location
    VISTA AL RIO FL
    Posts
    1,725
    +1
    69
    Also is a lot easier if you use a vise to hold the impeller tool!!

  4. #4
    This is how I run a jetski shop in the desert nmpeter's Avatar
    Join Date
    May 2008
    Location
    Elephant Butte New Mexico
    Posts
    6,518
    +1
    1,266
    autozone has the three giant hex sockets for ( 10/12/14) about $15

    my go to tool..I was sure they'd fail quickly but these happen to be of good quality.

    I always clamp the impeller wrench in the vise when I have one that uses the hex fitting.

    remember..always pull..never push a wrench.

  5. #5
    I've seen photos on here of guys fabbing impeller tools attached to tow hitches, which makes mobile impeller changes and pitch adjustments easier. How are guys attaching the tool to the hitch?

  6. #6
    Moderator beerdart's Avatar
    Join Date
    Aug 2006
    Location
    CT
    Posts
    25,929
    +1
    1,407
    Welding.

  7. #7
    Click avatar for tech links/info, donation request K447's Avatar
    Join Date
    Jul 2007
    Location
    near Toronto, Canada
    Posts
    36,575
    +1
    1,272
    Quote Originally Posted by Ferrari Steve View Post
    I've seen photos on here of guys fabbing impeller tools attached to tow hitches, which makes mobile impeller changes and pitch adjustments easier. How are guys attaching the tool to the hitch?
    I suppose the tool(s) could be mounted on the trailer frame as an alternative to the tow vehicle hitch.

    All depends on what makes the most sense for your equipment.

    Fab up a small 'workbench' and bolt that to the trailer. Take it off when you don't need it

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Removing water from the hull below the bilge pump level
    By jcat in forum Yamaha Open Discussion
    Replies: 8
    Last Post: 12-16-2015, 02:01 PM
  2. How do you remove the supercharger shaft from the housing
    By dandlwelder in forum 4-Tec Performance
    Replies: 5
    Last Post: 06-02-2011, 08:32 PM
  3. Removing Impeller shaft/bearing from pump
    By PropOrJet in forum Sea Doo Open Discussion
    Replies: 0
    Last Post: 08-18-2007, 12:15 AM
  4. How to remove scratches from the hull
    By BlackJack1 in forum Sea Doo Open Discussion
    Replies: 5
    Last Post: 06-10-2007, 03:14 AM
  5. 9psi From the Vortech Impeller
    By Antiguan FZR in forum 4-Tec Performance
    Replies: 15
    Last Post: 04-01-2007, 12:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •