Results 1 to 8 of 8
  1. #1

    Join Date
    Aug 2010
    Location
    Australia
    Posts
    65

    Protec Controller Wiring?

    Anyone have an installation and switch setting sheet for the Protec powervalve controller?
    Can the 1200 controller be used on an 800?
    Thanks


  2. #2
    I pm'd you the link and yes used on either 800 or 1200

  3. #3

    Join Date
    Aug 2010
    Location
    Australia
    Posts
    65
    Whatt RPM do you set it on for a stock ski?
    What rpm does the powervalves open at without a controller

  4. #4
    I just looked. i cant find any rpm number in the manual as its built into the cdi nd cant be changed. I would think you would want them to open around 5k rpm or so. the reason i used the controller is that it would keep them open for a longer period of time if it was choppy conditions. They wouldnt close right away.

  5. #5

    Join Date
    Aug 2010
    Location
    Australia
    Posts
    65
    It wont work on a stock ski. I have had it set at 4500 and 6250 and the powervalves open too fast for the engine to build up rpms and it bogs down. Once you get it above 6000 rpm its fine. I think there meant for modded engines.

  6. #6
    i first had it on a stock 66E engine and it worked fine.

  7. #7

    Join Date
    Aug 2010
    Location
    Australia
    Posts
    65
    Mines a 1200 66v engine. Protec advertise 2 contollers. 1 for a 1200 and 1 for the 800 Ill try it on my WB800R. It has a 66E engine in it

  8. #8
    I never knew there was 2 different part numbers.....Sorry about that. i would call them though because the PV motors are identical so im guessing the signal is as well. I have interchanged 66v and 66e pv motors between skies it never made a difference. So why would the signal be different?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FS - Parts Protec CDI, Power valve controller and power valve motor. $450 shipped obo
    By CanadianGPR in forum Yamaha 2 Stroke Skis
    Replies: 1
    Last Post: 05-28-2013, 08:20 PM
  2. broken efi fuel controller ground wire...
    By Mike's GPR in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 05-28-2012, 08:54 PM
  3. power valve controller motor wiring 5pin to 3 pin
    By brandn in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 08-04-2009, 11:11 PM
  4. EFI controller ground wire?
    By Pale Rider in forum Yamaha PWC Performance (2-stroke)
    Replies: 7
    Last Post: 03-31-2009, 04:23 PM
  5. accessory wire?
    By nitro rxp in forum 4-Tec Performance
    Replies: 4
    Last Post: 03-10-2008, 06:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •