Results 1 to 7 of 7
  1. #1

    260 steering if sensor

    Hi guys got a quick one ?
    I have a old umi steering set up here off a Zxi 1100 I can set it up and use it on a 260x
    if I disconnect the ic sensor is it going to stay in limp mode or do I have make and set it up too ?
    Thanks for your replies. ( ic sensor )


  2. #2
    nicjak's Avatar
    Join Date
    Mar 2008
    Location
    Warragul, Downunder
    Posts
    7,794
    +1
    625
    you can just unplug it

  3. #3
    nicjak's Avatar
    Join Date
    Mar 2008
    Location
    Warragul, Downunder
    Posts
    7,794
    +1
    625
    hey trav just checked on all part numbers to change i/c from 260 to 300, all the same. all you need to do is cap the top of the i/c and remove the fitting from the manifold and use a plug to block it. then just run a piece of rubber hose from the i/c outlet in the pump tunnel to the rear of the ride plate tie it in and put a barb water hose fitting in the end of the hose for reverse flushing so much easier than the old dual bottom feed setup.

  4. #4
    Thanks mate again working on it ! put a 9/17 scat prop in the other day and dumped it in the surf ! Loved it great bottom end ! LOL

  5. #5
    nicjak's Avatar
    Join Date
    Mar 2008
    Location
    Warragul, Downunder
    Posts
    7,794
    +1
    625
    you can cheat trav and get extra height out of the stock steering retaining the telescopic adjuster by placing a block between the adjuster and spindle column. i love it this way best of everything.

  6. #6
    Thanks mate , just had $400 of umi steering sitting around thought I could use it and play around with it !
    I but 2 wedges in too stock 2 deg and a R&d 1 deg ( 3 deg ) nose sits right out of the water great in the surf ! LOL

  7. #7
    nicjak's Avatar
    Join Date
    Mar 2008
    Location
    Warragul, Downunder
    Posts
    7,794
    +1
    625
    bet it bucks like crazy in the flat water though possibly even slowed it down?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 72
    Last Post: 07-05-2016, 05:33 PM
  2. RXP-X 260 steering issues?
    By TheEngineer in forum 4-Tec Performance
    Replies: 19
    Last Post: 09-23-2014, 10:19 PM
  3. Rxtx 260 steering column
    By danieletrono in forum 4-Tec Performance
    Replies: 2
    Last Post: 08-13-2012, 08:16 PM
  4. 2012 RXT iS 260 Steering and other issues....
    By Birdman in forum Sea Doo Open Discussion
    Replies: 6
    Last Post: 05-31-2012, 03:23 PM
  5. SEADOO RXT X 260 Steering-System...
    By nini engineering in forum 4-Tec Performance
    Replies: 3
    Last Post: 06-06-2010, 05:34 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •