Results 1 to 7 of 7
  1. #1

    2003 Ultra150..blew out motor mounts, coupler, and through hull bearing&boot

    Anyone have any suggestions on where to get replacement parts and anything else to look for or replace that I might miss. I need a download of a manual. I heard that Monkey grip motor mounts work good. I blew them out jumping waves yesterday. Any responses are greatly appreciated! Thanks
    Last edited by brucer; 12-10-2013 at 01:26 PM. Reason: year missing a 0


  2. #2
    steve45's Avatar
    Join Date
    Feb 2008
    Location
    Texas
    Posts
    5,014
    +1
    285
    Not familiar with Monkey Grip motor mounts. Mine has OEM, but I replaced them at about 150 hours. I do a lot of jumping and spinning with mine.

  3. #3
    wotxxxsd's Avatar
    Join Date
    May 2012
    Location
    Orlando
    Posts
    3,928
    +1
    472
    I think you can get those items here in the hulk store for 10% off and they are oem..

  4. #4
    Spooling's Avatar
    Join Date
    Sep 2011
    Location
    West Coast of Florida
    Posts
    1,285
    +1
    177
    I purchased the mounts for my Ultra-150 from a company called ProMarine.

    http://parts.promarineusa.com/produc...50/1/1/57-1144

    Good Luck !!!

  5. #5
    steve45's Avatar
    Join Date
    Feb 2008
    Location
    Texas
    Posts
    5,014
    +1
    285
    Don't make the mistake I did; I ordered two front mounts without realizing that there is only one mount in the front.

  6. #6
    I stick with wsm parts. There rear mounts arr slotted to better align the drive shaft. I normally order from atlanticjetsport.com

  7. #7
    Spooling's Avatar
    Join Date
    Sep 2011
    Location
    West Coast of Florida
    Posts
    1,285
    +1
    177
    If you "remove and replace" ONE engine mount "at-a-time" - this eliminates the need to re-align the engine/output shaft.

    Indeed a time saver and IMO you can't get better than the factory alignment.

    Good Luck !!!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Remove boot and through hull bearing (Genesis)?
    By HiPeRcO in forum Polaris Open Discussion
    Replies: 29
    Last Post: 09-16-2016, 12:17 PM
  2. SOLD all motor mount bolts and heavy washers
    By ou812 in forum Sea Doo Classifieds
    Replies: 4
    Last Post: 09-24-2015, 02:57 PM
  3. Replies: 0
    Last Post: 12-10-2013, 01:20 PM
  4. WTB WTB--'Short' pump drive shaft and Thru-hull bearing
    By johnsonmtz in forum Polaris Classifieds
    Replies: 5
    Last Post: 07-05-2010, 10:36 PM
  5. 99 xpl motor mount check and replacement
    By jasen 2007 in forum 2-Stroke Performance
    Replies: 1
    Last Post: 05-15-2010, 10:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •